Manual windows to flash
The manual way
1. Insert your USB flash drive.
2. Hit WIN+R, type cmd and click OK.
3. Type diskpart and hit ENTER
4. Type list disk, hit ENTER and identify the disk number for your USB flash drive. You MUST be very sure of this or else you’ll be formatting the wrong drive later on. If you have only one hard drive, then normally your USB flash drive will be disk 1.
5. Type select disk 1 and hit ENTER
6. Type clean and hit ENTER
7. Type create partition primary and hit ENTER
8. Type select partition 1 and hit ENTER
9. Type active and hit ENTER
10. Type format fs=fat32 and hit ENTER
11. Type assign and hit ENTER
12. Type exit and hit ENTER
13. Insert the Windows 7 installation DVD disc and copy everything from the DVD to your USB flash drive.
14. Boot up your computer with USB flash drive. You will need to go into your BIOS and make sure it is set to boot from flash devices. If you got it right, the Windows 7 installation should load from your USB flash drive.
